SciELO - Scientific Electronic Library Online

 
vol.25 número3Resistencia al aplastamiento de pernos de acero en cuerpos de prueba de madera de acuerdo con las normas técnicas ABNT NBR 7190:1997 y ASTM D5764:2007Estrategias mecánicas de las plantas arborescentes: enseñanzas estructurales de los árboles índice de autoresíndice de assuntospesquisa de artigos
Home Pagelista alfabética de periódicos  

Serviços Personalizados

Journal

Artigo

Indicadores

Links relacionados

  • Em processo de indexaçãoCitado por Google
  • Não possue artigos similaresSimilares em SciELO
  • Em processo de indexaçãoSimilares em Google

Compartilhar


Ingeniare. Revista chilena de ingeniería

versão On-line ISSN 0718-3305

Resumo

MORALES TAMAYO, Yoandrys; ZAMORA HERNANDEZ, Yusimit; ZAMBRANO ROBLEDO, Patricia del Carmen  e  BELTRAN REYNA, Roberto Félix. Turning performance analysis using coefficient of tool life in relation to the volume of removed material. Ingeniare. Rev. chil. ing. [online]. 2017, vol.25, n.3, pp.501-509. ISSN 0718-3305.  http://dx.doi.org/10.4067/S0718-33052017000300501.

The austenitic stainless steels are difficult material to machine due to their high strength, high ductility and low thermal conductivity. The aim of this paper is to propose a new criterion for assessing the performance of high speed turning by relating the flank wear with the volume of material removed. The influence of cutting parameters on the coefficient of life in relation to the volume of material removed was analyzed using analysis of variance and multiple regression. The investigation showed a better performance with the GC 2015 insert in both cutting speed. The analysis of factorial variance showed a significant effect of the machinization time in the coefficient of life in relation to the volume of material removed.

Palavras-chave : High speed turning; stainless steel AISI 316L; flank wear; variance and regressions analysis; volume of the cut metal.

        · resumo em Espanhol     · texto em Espanhol     · Espanhol ( pdf )